BL - U-bar version, with two flanged washers
BLC - U-bar version, with two flanged washers and GN708.1 spindle assembly
FL - Solid bar version with clasp
GN810.4 Vertical Acting Toggle Clamp, Stainless Steel, Safety Hook, Verical Mounting
Stainless steel toggle clamps, GN 810.4 are latched in both end positions. In the clamped position, this prevents unintentional opening or opening caused by vibrations; and in the open position, it prevents self-closing of the toggle clamp, such as due to an extended clamping arm. The latching can be disabled with a single hand to allow for opening / closing.
They work according to the toggle principle: lever and clamping bar move in the same direction. In the clamped position the operating lever is in its vertical position.
Toggle clamps in the U-bar version with two flanged washers (type BL) can accommodate an application specific clamping screw. A clamping screw with neoprene rubber tip is also included for type BLC.
Type FL can either be used by welding the clasp which can then accommodate an application specific hold-down fastener component, or by utilizing the bar in conjunction with GN809 holders for clamping screws to hold the work piece in place.
Stainless Steel NI - AISI 304
All moving parts lubricated with special grease
Hand grip - High quality, oil resistant, red plastic
Clamping Screw GN708.1, type A, Stainless Steel AISI 304, Rubber tip 85 Shore A
GN801 clamp mounts for toggle clamps (for type BL)
GN809 clamp mounts for toggle clamps (for type FL)