GN808.2 Universal Joint Shaft, Steel, Friction Bearing
Universal joint shafts with friction bearing GN 808.2 do not only bridge the misaligenment of two shafts, but at the same time they offer a length compensation. The power transmission is achieved by two universal joints DIN808 (type EG) a splined shaft and a sliding sleeve.
It is important to check the accuracy when connecting the splined shaft to the sliding sleeve. The markings => <= have to be opposite to each other.
Any kind of misconnection leads to an inhomogeneous output and to a quick abrasion.
Besides the different types listed in the table below for l1-l2, and for design-engineering reasons limited lenght l1, almost each desired length can be provided.
Steel ST, blank.
Joint bearing areas / pins /bearing sleeves, case hardened.
Universal joint shafts with d1=16 have instead of the spline shaft a hexagon shaft.
* The universal joint shafts specified in this table are available in stock (bore d2 with keyway K). Otherwise universal joints shafts for each application are specially designed.
-Different lengths l1 and l2
-Bores without keyway
-Bores with square
-With other or unequal bores