GN286.9 Swivel Clamp Connector Joint, Plastic

Choose your Part

Please select desired options to reveal part number, price and availability

Options

Type S - Stepless adjustment

Type T - Stepped adjustment with 10° divisions/serrations 

Identification number 2 - With three socket cap screw DIN 912, Stainless Steel

Product Description

GN286.9 Swivel Clamp Connector Joint, Plastic

In the initial position, the clamping bore axes of the swivel clamp connector joints GN 286.9 are in line with each other and can be swiveled by ±90°. They hold typical construction tubes with full surface contact over the entire cross-section of the bore.

At the screw locations z₁, the socket cap screws reduce the bore cross-section for clamping. Adapter bushings GN290 can be used to reduce the bore cross-sections to smaller diameters.

The screw location z₂ serves for fixing the joint axis, which can be adjusted continuously or in 10° steps, depending on the type.

For clamping without tools, the socket cap screws can be replaced by the adjustable hand levers GN911.9 listed in the table as accessory.

Specification

• Plastic - technopolymer (Polyamide PA). Glass fibre reinforced, temperature resistant up to 100º C, matte finish
• Black, RAL 9005 SW
• Grey, RAL 7040 GR
• Socket cap screws DIN912 - stainless steel AISI 304
• Hex nuts DIN985 - stainless steel AISI 304, self locking with polyamide ring